SSP limit / Halt Time Adjustability during render
SSP limit / Halt Time Adjustability during render
Would it be possible to enable the changing of ssp and halt time limits once render is started?
Re: SSP limit / Halt Time Adjustability during render
Try to change it in the queue list (it should work, but never tested) .
"... nor 0.2 galaxys, nor 0.8 little chikens ..."
Re: SSP limit / Halt Time Adjustability during render
Yes, you can edit the halt parameters in the render Q BUT:
if you wanna go for 1000 and start typing 1... render halts immediately -.-
So you need to copy & past a value here!
The predefined halt condition is still valid, so once reached before the Render Q value... render halts!
if you wanna go for 1000 and start typing 1... render halts immediately -.-
So you need to copy & past a value here!
The predefined halt condition is still valid, so once reached before the Render Q value... render halts!
polygonmanufaktur.de
Re: SSP limit / Halt Time Adjustability during render
Curiosities...
Then, if high values are defined in the inifile.xml and pasting the values carefully ... Works?
In the inifile.xml is about to add this two lines in the render settings section with the desired max. parameter:
Thanks in advanced.
EDIT: works fine, thanks for the tip, Zom-B.
the value of -1 means no halt>infinite time, spp...
Then, if high values are defined in the inifile.xml and pasting the values carefully ... Works?
In the inifile.xml is about to add this two lines in the render settings section with the desired max. parameter:
Code: Select all
<halt_time>-1</halt_time>
<halt_samples_per_pixel>-1</halt_samples_per_pixel>
EDIT: works fine, thanks for the tip, Zom-B.
the value of -1 means no halt>infinite time, spp...
"... nor 0.2 galaxys, nor 0.8 little chikens ..."
Re: SSP limit / Halt Time Adjustability during render
Ahh, nice workaround! Thanks to the both of you!
Who is online
Users browsing this forum: No registered users and 41 guests