Page 1 of 1

Indigo settings problem

Posted: Sun Jun 12, 2016 4:50 am
by HBK
Hello,
I just installed Indigo for Revit and i'm trying to follow this tutorial to install and start using the renderer:
http://www.indigorenderer.com/documenta ... t-tutorial
The problem is that when i go to "edit render settings" and select the view that i want to render, then click ok, it ignores it and always starts rendering the {3D} default view. Anyone knows how can i solve this?
Thank you all! :D

Re: Indigo settings problem

Posted: Mon Jun 13, 2016 11:37 pm
by gjengi
We're experiencing the same problem too. Is it best to roll back to an earlier version for the time being?
Thanks, Jen

Re: Indigo settings problem

Posted: Tue Jun 14, 2016 1:00 am
by arc en ciel
change rendering mode or click on "Enable OPENCL rendering"
reajust Render mode if you nedd it
start rendering, it will use an updated view

Re: Indigo settings problem

Posted: Tue Jun 14, 2016 9:11 am
by Oscar J
I think this is a general Indigo problem with how region rendering works currently. There has been some work done updating that afaik. :)

Re: Indigo settings problem

Posted: Wed Jun 15, 2016 8:45 pm
by gjengi
Ah, ok. Is there any work around, as I can't seem to find the relevant settings that arc en ciel has suggested in the revit settings, and we'd like to use Indigo to generate some renders for an upcoming competition?
Thanks

Re: Indigo settings problem

Posted: Thu Jun 16, 2016 12:27 am
by arc en ciel
hello

I was talking about settings in Indigo Renderer application.
I don't use Revit.
did you render inside Revit directly ? in this case i don't know...

Re: Indigo settings problem

Posted: Wed Dec 07, 2016 10:17 am
by arkitek
i am having the same problem, it keeps defaulting to the standard 3d-view any fixes on this?